|
1) Uncover the dome shape glass on the top of camera, then
place the camera vertically to the center part of camera out. |
|
2) Follow the instruction lable inside the case of the camera, push
the center part of the camera then twist it to left to open. |
|
3) For the setting of Address Select switch, it is used to set address
of the PTZ camera from 1- 1023. The coding switches from DIP-10 to DIP-1
are equivalent to a 10-bit binary digital. The state "ON" of
each bit means 1 while "OFF" means 0. For this example, we are
using address 1 for this PTZ camera 1, i will set DIP-1 to ON, and the
rest of them are OFF. |
|
4) This table shows states of coding switches of some addresses. |
