netZeye.com

DDNS

The Dynamic DNS is an application that allows users to register domain names that always point to their Multicam systems. This application is only necessary when your Multicam system is using a dynamic IP address. If so, the DDNS will update Multicam system’s IP address to DNS Server in every 10 minutes. Therefore, even if your Multicam system’s IP address changes, you can still locate it by using the registered domain name.

Dynamic DNS supports Windows XP, Windows 2000, and Windows Server 2003 only, but not supports Windows 95/98 or ME.

Dynamic DNS uses ports 80 and 81 to upload IP address over the Internet. If your Multicam system is connected behind a router or firewall, make sure port 80 and 81 are open. Dynamic DNS will only upload global IP addresses. If your Multicam system is using virtual IP, NAT port mapping should be done first.

	1) Locate DDNS Setup program from Setup CD Open DDNS Folder.
	2) Run SETUP.exe Keep on going Next until Finish.
	3) Double Click Dynamic DNS Service from Desktop to Start
	4) Click Register.
	5) If you cannot see this page, close it and reopen it again. Sometime it cause by service busy. Register your DDNS website name For example, If you choose "netZeye" as your username, your DDNS website name will be: http://netZeye.dipmap.com
	6) After you get Send, You should get confirm information Click [x] to close this information page.
	7) Now, you are back to this screen. Please enter username & password that you just created. Click Save.
	8) After You click Save, You should see Update successful messege. If you still see Failure messege, possible situation: 1. Server busy. Maybe it take more time to update, try again later. 2 . Is your Multicam software minimize? If not, please make sure Multicam software is ON. 3 . Is your Port 80,81 allow to transfer signal?
	9) Please click [ _ ] Minimize Remember: Do not chose close the program. If you close it, then your webname cannot update automatically.
	10) Open Internet Explorer type: http://netzeye.dipmap.com If you use different port number than 80, please type http://netzeye.dipmap.com:2550